Struggling with URFRx

Struggling with URFRx

I have been struggling with getting URFRx working for a while.

I have an Arduino nano connected directly to my spare Livebox; it has been loaded with UniversalRFRx.ino. 

If I telnet into the Livebox and monitor microcom -s 57600 /dev/ttyUSB0 I can see the words “starting” and streams of RF data when I send 433 MHz transmissions. 

I have put a valid RF code in the URF Rx rf 1.

I thought I would see a state change in the xFx message viewer, when I transmit and then receive the code in URF Rx rf 1, but all I see is the following.

xap-header

{

v=12

hop=1

uid=FF00EE01

class=xAPBSC.info

source=dbzoo.livebox.urfrx:rf.1

}

input.state

{

state=?

}

I hope I have not missed something glaringly obvious, but I have now exhausted my limited HAH knowledge.

Once I get over this stage I would like to trigger a light when a HE105 door switch is broken. Will concentrate on this once I can see a state change in the xFx.

Any help would be very much appreciated.

Kema…